Search results

I got the nice fella from magnacore to make me a custom set. I'll get on that forum when im home again cheers

Jeez every one needs sumps lol! I'm after a full sump setup for a 2uz for my solid front axle, info on any 4x4 breakers in the UK that might have petrol landcruisers would be handy too, location Scotland, happy to pay extra for overseas Thanks.

sorry, there ford edis coil packs 1st gen with the tall posts on, and yup its 36-1 my bad

Yea I was looking at that but the difference between sequential and non sequential would make the maps different, or I would think anyway. I'm still learning very much so! I even googled for screen shots of maps and no one seems to have listed any :( I just bought this ecu new as an ms2 as I...

Hi, just finished wiring in an MS2 into a landcruiser for a bit of fun in the mud I'm running edis 1 packs and 32-1 crank trigger on the standard tube headders. And im trying to get it to run enough with out a wide band lambda for "testing" as funds have some what dried up for one right now...

cheers vince! looks like these leads might get a bit pricey :rolleyes:

howdo folks, just looking for advice on plug leads to go from the 1uz to the edis coil packs. wondering if anyone has found standard leads that fit or if they need to be custom ones. i normally wouldn't ask such a simple question because it must have been done so much before. but i've...

deffinatly going for a 32-1 trigger wheel. thats an easy mod for me, its the electronics part that baffles me, getting there now though

awesome :D thanks when are you about? are there any ls400 parts you need? in fact i'll send a pm and get your address cheers

hi, looking for a pair of the rubber engine mounts ls400 type but i think the sc400/soarer have the same ones too. cheers

hey, looking for all the associated stuff to get a rear sump on my v8. preferably in the uk but not opposed to a bit of shipping if the price is reasonable. cheers, Ali.

i'v only just realised the MS box can run coil packs or COP's on its own without a igniter or driver

i have all parts of an LS400 available apart from engine and ancileries its a 1993 i think with 147k miles things like ECU and all other controll boxes ignition components steering suspension auto box (intermittant fault) diff interior dash ..................

sorry..... whats COP? :o

cheers for the reply, I'm more toward running the edis system instead of the dissys so i can waterproof the whole lot as much as possible

i have a ls400 1uzfe with a front sump and need a rear sump preferably in the uk thanks

i think i'v got it now anyway so here just incase its any use to some one shopping list :- 1uzfe megasquirt ms2 extra ecu 100mm trigger wheel air temp sensor water temp sensor o2 sensor crank sensor edis8 module 2x edis coil packs and i'v found if i buy it from www.extraefi.co.uk...

hey, daft question time :o i'm fitting a 1uz to a LJ70 land cruiser and want to use megasquirt, i figure that i want the basic system as its just for an off roader so ms1 with edis wasted spark , and i think i need a trigger wheel which i can make from a universal one, crank sensor, coolant...