Search results

Just a thought? Pins 9&10 on the small connector If I ground pin 10 I would have first If I ground both - second If I ground pin 9 - third Am I close?

Jim - I have wired it to the back of the speedo head I have not done anything with the neutral start wiring It has a manual behind it and I have wired the starter straight to the starter relay in the factory fuse box Are you suggesting that I need to put 1 of the shift solenoids to earth? I...

I have hooked it pin 2 in the smaller e9 connector - spd speed sensor 1 if it was the number of pulses from the vss, why does it do it in every gear regardless of speed but directly relational to rpm?

1992sc400 with 40 40 40 pin ecu I have put it all into a Hilux I had a few dramas with knock sensors Firstly new dead sensors then wrongly boxed sensors But finally sorted I now have a 3750 rpm rev limit It will rev out properly sitting still It has a manual gearbox behind the motor If I...

I should add it is all in a hilux

I torqued the new sensors to 33 ft lbs

rather than start a new thread code 52 55 I have replaced both knock sensors I have checked continuity from the plug at the back of the motor to the ecu I have not checked it from there to the knock sensor but it looked fine, I will have to pull the manifold off to check that and have...

Thanks Exactly what I needed Neil

Hey all Anybody aware of what is the correct tension for new knock sensors. It is a 1992 sc400 Thanks neil

pretty well is not very well which makes me sad panda I will get the old fuel gone and reset the codes and report back

hi it doesn't run bad - runs pretty well just the light is on they were replaced by a mate who works for Australian computer co one of the injector driver tracks was damaged but has been repaired. neil

hi all to start off 92 1uz into rzn 149 hilux manual not auto I have the motor running well but code 42 I seem to remember reading somewhere to put pin 76 to ground nothing else for this? I also have codes 52 and 55 but I hope that they will be just be a tank full of 2 year old fuel for...

should the pcv/catch can be plumbed in after the maf not before?

so to the ignition switch it goes

so m rel goes to the earth side then even though it is a 12v pos output?

why was the cat clogged up?

almost finished a 1uz into a 2wd surf and i would be keen to see others neil

are the injectors pulsing and not stuck? pretty common for this to happen on conversions. neil

hi, i have a couple of questions about your radiator. 1. have you had any problems with both outlets in the top tank? 2. you must have put a baffle in between the two outlets making it effectivly a dual pass radiator? 3. good water pump flow? thanks for your time neil

ahhh yes :D just the one from the batt to body and engine to body just give the metal where you bolt it to the body a good cleah so you have nice bright metal ( no primer) and recoat it when done neil