Recent content by nzsimon

Reply No it wasn't ready. But it was in the national hot rod show

. I don't think he does but it works well I am also using a flappy paddle setup radio operated from shrifter in the USA to "talk" to kdogs controller so totally tiptonic

Video link http://youtu.be/dRABaJu71JQ

Video Not sure if this will work thought I was being creative turns out the camera disagreed NA didn't work

Video Not sure if this will work thought I was being creative turns out the camera disagreed

Tell me about it a divorce ran me out of cash

. Very cool !!!!!!!!!!

Last one Never polishing a whole engine again

More Another angle goes like a go cart

Posted before but here is the nearly finished and now road going 32 with 1uz and kdogs trans controller

Rocker covers They are easy just cut off the plastic bit down the centre of the heads and replace with 5mm alloy only have to drill 2 holes in each one http://www.lextreme.com/forums/showthread.php?t=14536

Bigger pic Step back for better view

Here's mine Best pic I could get without pulling the rad

Tidied Then I cut the alloy casting for the tensioner and made it look prettier

Only one left I deleted all the ancillaries as dint need them and moved the alternator up a bolt hole and made it swing able made a bracket out of stainless and polished it Pictured is the 3 stages paper panel steel to check if it worked and the finished item