Recent content by jmswltn

1uzfe block cam file does anyone have the 1uzfe block to bell housing pattern cam file they would like to share? or possibly a link to where it is posted..

have you gotten this sorted?

dewme do you have a current tune somewhere? are you wired into the stock ecu plug with ms3x? i have all the parts but have not installed the ms3x in my ms yet

whats the story on that intake manifold says TRD looks to be a carbie setup with injector bosses welded on.. a little :confused:

your parts list can change depending on your ability to fabricate. 1st: avoid using the auto trans from the 3vze. it uses a hydraulically powered transfer case, essentially being a transmission behind another transmission. this equates to taking the 250 horses the uz puts out and turning it...

still trying to figure out how you guys are getting so much better economy than me. Best i could get is 15 litres/100km that was full tank 95% highway i shouldnt be getting beat out by a full size ford 4x4 for mileage

I have a 341 it has a cable and 4 solenoids, Does the cable only control kick down?

Will a Bad knock sensor retard timing but not throw a code. Engine/ecu from a 90 ls400.

A little off topic but how is your motor located around the steering stabilizer? I cut mine off along with the loop it mounted to, I have a front sump.

what plug wires are you using? are you on msextra forums?

any info on why you couldnt directly connect to the other knock wire, without the cap. i did this and the code never came back but seems a bit low on power and has bad fuel economy (11mpg~19l/100 in a 4runner/surf)

what do you mean edis 1 packs? and ill assume you mean 36-1 crank trigger

there is a few maps out there that are for ms3x. you can take those and transfer over the values by comparing or screenshot trouble is the fueling and ignition will both be off. i was in the process of doing the same but decided to wait till i could upgrade to ms3x problem is its a $460...

mike add a turbo or something to your 3rz my 1uz 4runner/surf is getting around 19l/100k with the auto behind it even after full tune up: caps, rotors, plugs, wires, multiple fuel treatments, good compression and trans working optimally im getting around 260-280km between fill ups.. its...

"the igniter sends an ignition confirmation signal (IGF) to the ECU. The ECU stops fuel injection as a fail safe function when the IGF signal is not input to the ECU." check continuity between igf on that igniter and the ecu pin. you may have a break or loose terminal pin this is if you...