Due to a lack of time I have had to give up on trying to fit a 1UZ into my porsche 944 so have a few parts for sale as detailed below.
1UZ header/manifold flanges, 10mm thick mild steel. Brand new, bought from the USA and had shipped over. £60 + p&p
I had all the parts sorted to have the...
Luckily Smiffy has a soarer sump he can sell me,
Before I buy would somebody be able to confirm the Soarer sump is a rear sump. I asked the guy selling but he said he only sold and worked on soarers so couldn't comment on the difference between then ls400 etc....
Thanks
Daniel
I think a rear sump would fit around my rack but I was also hoping to make the sump wider at the bottom so it isn't as deep due to clearance problems.
Speaking to some one in work today I may be able to get one made by one of our fabricators as a favour/on the cheap as we are putting a huge...
Im currently in the middle of fitting A 1UZ into my 1984 Porsche 944.
I used the standard 1UZ bellhousing and shortened the torque tube housing (not the shaft itself) so it would fit with a custom adaptor which bolts between the bell housing and the torque tube.
I used a MR2 turbo flywheel...
I am pushing along nicely with getting a 1UZ in my Porsche 944 but now have the issue with the sump being in the way of the steering rack.
It seems to be near imposible to get hold of a rear sump assembly over here in the UK so I was going to fabricate my own using the CAD file I found on...
Thanks for the info Bushwhacker.
The 34 pin loom on the diagram looks different to my loom as 2 of my injectors share one ecu pin where as in the diagram each injector has a ecu pin. I think to be on the safe side and to make sure I dont fry my ECU I will need to buy a 28 pin plug to find...
Hi Guys
I have ECU pn:89661-50160 which i am trying to wire up to my porsche 944 now I finally have the engine fitted but cannot find a pin out for the type of ECU I have. It is a 34,22,16,28 type.
I have manage to buzz out and find what most the pins on the engines loom are for (the...
Good morning,
Does anyone know the size and type of union used on the end of the fuel pipe that supplies the fuel rail? (the opposite end of the banjo) I was wanting to try get a matching connector fitted to the fuel feed line of my porsche 944 to make it a neater and safer fit.
Thanks...
Hi, Do you have non VVTI, piston rings? I just need one middle ring as i snapped one but will buy a whole piston if need be.
How much posted to Scotland if you have one available.
Thanks
Daniel
Hi,
I snapped one of the middle piston rings on my 1996 1uz and have managed to get a replacement ring off a later vvti 1uz. I measured and compared the rings but the newer replacement one is 0.010" thinner than the old one.
Do you think this ring would be ok to use? The rings are relatively...