1gz-fe engine specs?

[phongshader]

Andy,
are you able to source oversized bearings, rings and new valves?

[dulobast25]

cribbj,

you sya you know several guys running that engine?

Any ideas on a good source on where to get them?

Thanks

[cribbj]

There were 2 on eBay (USA) only a month or two ago, and located not far from you. No bids, although the price wasn't that bad, IMO (Buy it now for around $4K, IIRC)

Try contacting Mitch Pederson, the people that brought his in might help.

[ANDY R]

phongshader,

Yes, All parts are available from toyota, here in Australia anyway. Over here you have to either give them a vehicle VIN number or the actual part number. You also have to be a bit careful as these engines also came out running CNG (Compressed Natural Gas) those engine have different valve seats, pistons, rings etc. A good website for parts information is http://www.megazip.ru/ru/auto/toyota...403226#g403226

There is usually a couple of these engine available on the Yahoo Auctions Japan website but you will need a contact in Japan to be able to purchase them.

[phongshader]

Andy R
If you could you tell me what the deck height of the block is, pin height of the piston that would be great.
Thanks

[ANDY R]

I will get back to you ASAP, I am away on work at the moment.

[phongshader]

any measurements?

[UZX73]

I'm more concerned with the oem ecus for it, if they are really engine matched etc.
Seen a few go for $3k-4k

[redrocco]

Hi Andy, If you get a chance could you please measure the width of the 1GZ rods at the big end for me. Thats the last piece of info I need to check out a possible conversion from 1GZ rods and pistons to the cheep and plentiful Honda B16A rods and pistons.

[Hypoid]

Has anyone measured valves and ports? It would be great to know valve diameters, valve inclination, and port areas.