BigEv
New Member
- Messages
- 69
- Location
- Newcastle, AUS
hey, im planning a build on my 1uz engine. its going in an offroad 4x4 buggy and im after some info on running NOS. ive never worked with it before and any info would be good.
as for the engine im looking at building in 2 stages.
top end being valves/valve springs, ported polished, cams and individual throttle bodies.
then bottom end will be higher compression pistons and rods and the NOS will go on then.
ill probably only look at 100-150HP shots and only on straight wind out sections.
so yea any dos or donts etc would be tops.
thanks
as for the engine im looking at building in 2 stages.
top end being valves/valve springs, ported polished, cams and individual throttle bodies.
then bottom end will be higher compression pistons and rods and the NOS will go on then.
ill probably only look at 100-150HP shots and only on straight wind out sections.
so yea any dos or donts etc would be tops.
thanks
