NH/J Pajero engine bay dimensions

Discussion in 'Swap, Conversion, Transplant, Specialty Vehicles &' started by 1UZ-MX83, Jun 6, 2004.

  1. 1UZ-MX83

    1UZ-MX83 New Member

    Joined:
    Jun 5, 2003
    Messages:
    146
    Likes Received:
    0
    Trophy Points:
    0
    Occupation:
    Not much
    Location:
    ACT, Australia
    Does anyone here have (or have access to ) an early 90's Mitsubishi Pajero - preferably the SWB V6 version, although I imagine the LWB engine bay would be similar?

    Need to know the length, width and height (the usual 700mm Cube is what I 'm looking for).

    Am looking to buy one as a long-term project, so would like to know in advance if the project would be a goer...
     
  2. MaxPower

    MaxPower New Member

    Joined:
    May 11, 2004
    Messages:
    283
    Likes Received:
    0
    Trophy Points:
    0
    Occupation:
    Electronic Engineer
    Location:
    Perth, Western Australia
  3. 1UZ-MX83

    1UZ-MX83 New Member

    Joined:
    Jun 5, 2003
    Messages:
    146
    Likes Received:
    0
    Trophy Points:
    0
    Occupation:
    Not much
    Location:
    ACT, Australia
    Basically, yes.

    My wife wants a SWB Pajero (feels safer in that than our little Corolla for 'round town stuff), and I envisage a 1UZ mated to the existing manual gearbox etc. That package should be quite reasonable...

    (Just have to sell the damn Celsior first...)
     

Share This Page