1UZ VVTi Engine mountings dimensions

Discussion in 'Fabrication (Members Only)' started by cprinsloo, Dec 4, 2017.

  1. cprinsloo

    cprinsloo New Member

    Joined:
    Apr 11, 2012
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Occupation:
    Engineer
    Location:
    Nelspruit, Mpumalanga, South Africa
    Good day all,

    I need to fabricate new engine mountings for my 1UZ-VVTi, I was wondering if anybody have the distances (centre to centre) of the holes of the plate that bolts to the engine block? I tried to measure with the engine in place, it seems about 105 mm x 60 mm, but that was very rough measurements. Would appreciate it very much if someone has more accurate measurements.

    Thanks,

    Regards,

    Chris
     

Share This Page