Search results

does any1 know where i can purchase the plastic surround that allows u to install an aftermarket single DIN stereo.. there is a guy on ebay but he's a head ache and a half. By the way i live in australia but am will to purchase overseas..thanx

i have a similar prob with my 1990 ls400. Drivers side is lower and a few people told me its the air shocks wearing unevenly. Firstly let me tell u i dont have an answer for ur problem but i may lead u to it.. I have and aftermarket height controller in my car that was installed before i bought...

thanx alot guys for ur input and i did a bit of asking around and someone told me that the starting issue when cold (not the high idle when cold ) could be leaky injectors..I plan on doin a sevice on the car very soon and will get back to u with results.

I have a stock ls400 90 model and i was wondering if it was possible to run the signal wire that goes from the HU to the sub amp into an aftermarket amp, basically to give a better bass sound ( and replace the sub ). Ive located the amp on the left side of the boot but cant seem to determine...

Would this screw affect my idle speed when my car has reached temp (when its warm) or just when its cold?

Hi guys, i got a 90 ls400 and when i start the car in the mornings it takes about 3 seconds of cranking for it to start and when it does it stumbles for a couple seconds and then idles at around 1700-1800 rpm. If i dont crank it for the full 3 seconds and then try again it starts pretty much...

I had a proper look at the car and noticed that the left side of the car (passenger) is actually lower than the drivers side. The higher u go the more of a difference between the 2 sides

I recently purchased a 1990 ls400 which has an aftermarket height controller installed. My problem is that the front left side does not come up as high as the other side and is usually about an inch or 2 lower than the other side. It doesnt seem to be leaking as it stays constant at whatever...

hi guys, im in the process of purchasing a 90 ls400 and im wondering if anyone has purchased the workshop manuals on cd that they sell on the net? Are they any good ? do they contain the same info and diagrams as the factory workshop manuals that go for a couple hundred? Ive bought those HAYNES...