cprinsloo
New Member
- Messages
- 1
- Location
- Nelspruit, Mpumalanga, South Africa
Good day all,
I need to fabricate new engine mountings for my 1UZ-VVTi, I was wondering if anybody have the distances (centre to centre) of the holes of the plate that bolts to the engine block? I tried to measure with the engine in place, it seems about 105 mm x 60 mm, but that was very rough measurements. Would appreciate it very much if someone has more accurate measurements.
Thanks,
Regards,
Chris
I need to fabricate new engine mountings for my 1UZ-VVTi, I was wondering if anybody have the distances (centre to centre) of the holes of the plate that bolts to the engine block? I tried to measure with the engine in place, it seems about 105 mm x 60 mm, but that was very rough measurements. Would appreciate it very much if someone has more accurate measurements.
Thanks,
Regards,
Chris