Recent content by tatthep

  1. T

    Won't revs

    Thankyou what should i do?
  2. T

    Won't revs

    Um if you mean in normall mode when sw. Key on (IG) check engine will show usual the light is not flashing but if you mean check codes on diagnose con. Te1,e1 is it correct ? It show 47,56 i have read one article about code 47,56 not affect how much I do not know if this may be part of it
  3. T

    Won't revs

    And my plug have not wire
  4. T

    Won't revs

    In the diagram there is no telling with pin 14
  5. T

    Won't revs

    Um i dont know tomorow ill check it what wire,pin my ecu 26:16:22:26 pin
  6. T

    Won't revs

    Hi, my car won't revs up on N if driving on the road not problem What wrong ? (Engine swap)
  7. T

    Tilpipe Grey smoke somuch what wrong ?

    Ok i will do it my engine maybe first engine of 1uzfe
  8. T

    Tilpipe Grey smoke somuch what wrong ?

    Hey Now its bad i see grey smoke somuch out of exhaust i have not connected o2 sen i see my 8 plung have a much black color may be much fuel ? Why ? If engine bad its should have white smoke what causing ? What wrong ? Help me please..
  9. T

    1uzfe won't start

    Two days ago I sent an ecu to a neary repair shop. But he told me he is just checking a supply system is usual (the 5v power supply i dont know about that but i know it should be about some signal from cam,crank sen then ecu geting it and take 5v for injectors or other may be.. ) But I think it...
  10. T

    1uzfe won't start

    wired correctly have relay some system as EFI,MRel,Fc then a little more I got 47,56 code from the diagnostics plug in front of the engine But it can't take engine die i dont have scan tool
  11. T

    1uzfe won't start

    Yeah very sure wired correctly My ecu is like some vdo in youtube. The mains wire that makes the engine work is about four wire and one wire bigblack for starting. But I connect everything in the way, but it does not work, but I hook up other wire like the diagram and I think my big problem may...
  12. T

    1uzfe won't start

    Engine swap from ls400 ecu is 89661-50100 26,22,16,26 pin i changed coils or something else wrong only remaining ecu has not been tried not chang.
  13. T

    1uzfe won't start

    Hey everyone now my motor die problem is when i crank to start its run a few sec but it's not fire over it started just once even everyting fine to fire such as fuel pressure (3 bar at least) even to the hight prees it does not work, plungs at all is fired i think ecu may be issue because...
  14. T

    The engine runs one second after startup and then goes out.

    ahhh thank you so much for tell me i have diagram for my ecu it on ls400 sure but i connected everything correct. In addition i wondering more one small black (i have 2 wire small black near big black one wire black i seen it pair with nsw wire (black/white) this need to +12v (i told you...
  15. T

    The engine runs one second after startup and then goes out.

    Now engine work i fixed problem Problem is one black wire near bigblack wire not pair with bigblack But when hook up together then start it's wont start (black small wire is cold start injector cold start has two wire black one and blackred but blackred in my ecu plug pin not have wire out sure...


Top